Emergency guide

Burst pipe: what to do in the first ten minutes

A pressurized pipe keeps running until someone closes a valve. Do that first, and everything else gets easier.

Updated · Written for homeowners, with sources listed below

Quick answer

Close the main water shut-off valve, then open the cold taps to drain the pipes. Switch off power to any wet area at the breaker panel if you can reach it safely. Move belongings, photograph the damage, and contact a licensed plumber to repair the pipe before the water goes back on.

What do I do first when a pipe bursts?

  1. Close the main shut-off valve. If you don’t know where it is, see how to shut off the water to your house.
  2. Drain the system. Open the cold taps, lowest floor first, and flush the toilets once.
  3. Turn off the water heater so it doesn’t heat an empty tank.
  4. Make it electrically safe. Switch off breakers for wet rooms. Don’t stand in water to do it.
  5. Catch and move. Buckets under drips, furniture and electronics out of the way.

Ceiling bulging? That is trapped water and it is heavy. Keep people out of the room.

What should I do while I wait for a plumber?

  • Photograph and video the pipe, the water and every damaged item before you clean up.
  • Start drying: towels, a wet vacuum, fans and open windows if the weather allows.
  • Leave the water off. A temporary clamp or tape is a stopgap, not a repair.
  • Call your insurer early. Many policies expect prompt notice and reasonable steps to limit damage.

Why do pipes burst?

The common causes are freezing, corrosion in old metal pipe, water pressure that is too high, and physical damage during other work. A plumber will want to know which, because it decides whether you need one repair or a wider replacement.

What will the plumber do?

Find the break, cut out the failed section, replace it and pressure-test the line before restoring water. If the pipe is in a wall or ceiling, expect some of it to be opened. Drying and rebuilding are usually separate jobs done by other trades.

Common questions

Can I use water after a pipe bursts?
Not until the pipe is repaired or that branch is isolated. With the main valve closed the house has no water. A plumber can sometimes cap the damaged line so the rest of the home works.
Is a burst pipe covered by insurance?
Sudden and accidental bursts often are, but the failed pipe itself may not be, and neglect is commonly excluded. Check your policy and call your insurer.
How fast does a burst pipe cause damage?
Immediately. A pressurized line runs until a valve is closed, which is why shutting off the water comes before everything else.

Need a plumber to look at it?

Tell us what’s happening. Where we have a verified plumber for your ZIP code, we pass your request to one. Where we don’t, we tell you.

Request a plumber